If the problem persists, please contact our technical support team. Reset the switch and re-add it to the Deco network.Avoid physical obstructions and radio interference in the surrounding area.Move the switch closer to the Deco unit.Smart Automatic On/Off Photocell Sensor A19 E26 Porch With 76. If not sure, just reset the switch before you add. Melnor Water Timer HydroLogic 73280 GE 2pk 10W 60W Equivalent Relax LED HD. Make sure the switch is factory reset.Note: If the device fails to reset, please refer to the setup guide of the device’s manufacturer for more information.įail to search the switch / the switch becomes unreachable/offline The LED will begin blinking, indicating the device is reset and ready to pair with a network.While holding the button, plug in the device.Hold down the button on the front of the device (no longer than 4 seconds - if held for more than 4 seconds, the device will fail to reset).The LED will blink to indicate the device is reset and ready to pair with a network.įor 45852GE (GE Plug-In Smart Dimmer Switch):.Within 4 seconds, release the on/up button.Hold down the on/up button and push in the air gap switch.Lift/pull out the air gap switch at the bottom left of the rocker.This allows you to conserve electricity saving you time and money. Schedule custom times for turning your electronics on and off, or set a light to turn off after a set period in case you forget to switch it off. The LED will start blinking to indicate the switch is reset.įor 45857GE (GE In-Wall Smart Dimmer Switch): Manage Electronics Using a Light Switch Timer Manage all of your home's interior and exterior lighting with light switch timers.Quickly tap the top rocker of the switch 10 times.Then tap DONE, and the switch will list on the app. When the switch is discovered, tap NEXT and choose a location for the switch.Wait up to 60 seconds until the switch is discovered. ![]() To restart the pairing process, press the front-panel push-button). Power on the switch and the LED will blink (If a timeout occurs, the LED stops blinking.Launch the Deco app, tap the Add icon at the upper right corner, choose Smart Devices -> Switches/Plugs/Outlets -> In-Wall Smart Switch (GE/GE Link) -> NEW DEVICE.How to add a GE Smart Switch to the Deco network?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |